Red ROCKET BREAKOUT BOX Manual do Utilizador descarregar pdf (Página 13)

DECEMBER 22, 2009 © RED.COM, INC. 2009

2-5

2.4 CONNECTION CABLES

To connect the RED Rocket Breakout Box to the RED Rocket board, special cables are used (DMS-59-

to-2×DVI-D). They must be plugged into the DMS-59 connectors located on the slot panel of the RED

Rocket board. Each DMS-59 breaks out into two (2) DVI-D (DVI for digital data only), which are then

connected to the rear of the RED Rocket Breakout Box (refer to 3.1 SETUP OF RED ROCKET BREA-

KOUT BOX).

Figure 2-3: DMS-59-to-2xDVI-D Cable

To fully connect the RED Rocket Breakout Box to the RED Rocket board, two (2) of these cables are

required. In environments where quad display applications or similar are not desired, the major connec-

tion ’DVI A/B’ to ’DVI A’ between the RED Rocket Breakout Box and the RED Rocket board will work

sufficiently (refer to 3.1 SETUP OF RED ROCKET BREAKOUT BOX). Cable specifications are detailed in

section A.1 TECHNICAL DATA.

DMS-59

DVI 2

DVI 1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Sem comentários

Red ROCKET BREAKOUT BOX Manual do Utilizador Página 13