RED ORCHIDEA Instruções de Operação descarregar pdf (Página 45)

red

PELLET STOVES Chapter 6

INSTALLATION AND USE MANUAL

page 45

Problems/Causes/Solutions Technical service - Rights reserved - Reproduction prohibited

PROBLEM

LED

POSSIBLE CAUSES Solutions:

The stove is

signalling pellet

hopper temperature

over the safety limit

Led 0.

 Pellet load too high

 Room fan power too low

 Structure has overheated due to

reduced heat dissipation.

 Room fan faulty

 Wait for the stove to cool,

re-ignite it and decrease the

pellet load following the

instructions in section 4.10

 Wait for the stove to cool,

re-ignite it and increase the

fan using knob A

 Verify the correct

positioning of the stove

 Increase the smoke fan

speed according to the

technical manual

 Replace the room fan

The stove signals

anomalous

operation of the

smoke fan

Led +1

 Impediment in fan rotation

 Smoke fan faulty

 Check the reason for the

impediment

 Replace the faulty

component

The stove signals

smoke temperature

too high or smoke

probe faulty

Led +2

 Pellet load too high

 Unsuitable pellets.

 Room fan power too low

 Structure has overheated due to

reduced heat dissipation.

 Room fan faulty

 Smoke probe faulty

 Smoke outlet blocked

 Increase the pellet load

following the instructions in

section 4.10

 Remove the unsuitable

pellet from the hopper and

exchange it with one

recommended by the

manufacturer

 Increase the fan speed

using knob A

 Verify the correct

positioning of the stove

 Replace the faulty

component

 Clean the smoke outlet

The pellets

accumulate in the

grate

 Pellet load too high

 Insufficient combustion area.

 Pellets damp or unsuitable.

 Door open

 Smoke outlet blocked

 Gaskets worn

 Increase the pellet load

following the instructions in

section 4.10

 Make sure that the

combustive air inlet in the

back of the stove is free

from obstructions or

blockages

 Remove the unsuitable

pellet from the hopper and

exchange it with one

recommended by the

manufacturer

 Check that the door is

properly closed

 Clean the smoke outlet

 Increase the smoke fan

speed according to the

technical manual

 Replace the faulty

component

1 2 ... 40 41 42 43 44 45 46 47 48

Comentários a estes Manuais

Sem comentários